Garage door won't close: sensor repair in Easton

If the door won't close from the remote and the opener light blinks, the sensors are the first place to look.

Call (475) 239-2801

In short

If the garage door starts to close and comes back up, or the opener light blinks, the safety sensors near the floor are usually misaligned, dirty or have a damaged wire. Wipe the lenses and check both lights are steady; if it still won't close, a technician in Easton realigns or replaces the sensors and tests the safety reverse.

Opener, rail and torsion spring above a garage door with windows

Doors that won't close in Easton

Easton is farm and reservoir country: about forty percent of the town is watershed land, and more than twenty farms still work. In Upper Easton, where zoning is three acres, garages and barns sit well back from the road, and sensors have to cope with mud, hay dust, mice and long wire runs. Along the reservoir roads and in Aspetuck, damp air and fog settle in low spots, and the lenses stay wet into the morning. In Lower Easton, with one-acre lots, garages are attached and more conventional, and the usual cause is a bin or a ladder in the beam. Farm equipment parked close to the door often bends a bracket without anyone noticing.

Why a garage door refuses to close

  • Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
  • Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
  • Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
  • Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.

Quick things to rule out

  • Is anything in the path of the beam, even a leaf or a cobweb?
  • Are both sensor lights lit and steady?
  • Does the problem only happen at one time of day? That points to sun in the sensor.
  • Is the wall control's lock or vacation button switched on? It disables the remotes.

Anything beyond that, including limit and force adjustment, is a job for a technician, because a wrong setting can stop the door from reversing when it should.

How the repair is done

The technician tests the sensors and their wiring, realigns or replaces them, then checks the close limit and the force setting. Before leaving, the door is tested on a block of wood laid flat in the doorway: it has to reverse as soon as it touches it. If the door itself is binding in the tracks, that is corrected too, since a stiff door is often what set the opener off in the first place.

Around Easton

  • Reservoir roads: Homes near the Aspetuck, Hemlock and Easton reservoirs, where damp air is hard on wood doors and hardware.
  • Town center area: Around the town hall and schools, mostly single-family homes on large lots.

See the full Easton service area.

Garage door won't budge? Call first, force it never.

Keep people and pets away from a door that's stuck or crooked, unplug the opener, and give us a call.

Call (475) 239-2801
Call (475) 239-2801